8L (1996-2003)

TT / R32 Adjustable Control Arm Hardware Need to buy 1 off’s for a project? Want new/longer fasteners? Look below for the parts to get the job done! High radial load GENUINE FK JMX Series PTFE lined heim joint kits complete with protective...

This is the same great stuff used on jet engines to route bypass air. With a service temp of -80F to +600F its more than you will ever need. Use this with any of our 3” brake duct brackets. You can also add two 3” stainless steel hose...

GruvenParts.com is happy to release this Billet Upper Radiator Hose 4Y Coolant Fitting for VW Golf/Jetta/Passat/EOS and Audi TT/A3 with BPY Engine -- P/N 1K0-121-087H (1K0121087H). The OEM plastic 4Y connector used in the upper radiator hose...

GruvenParts.com has now released these billet aluminum intake manifold linkage arms for the VW/Audi 1.8T and 2.0T engines!. Ours are Guaranteed for Life! - Would VW / Audi say that about theirs ??! This GruvenParts.com billet linkage arm replaces...

MK5 3.2L VR6 Lightweight Pulley Kit You guys asked for Billet Aluminum super strong, super lightweight MK5 3.2L VR6 Pulleys and GruvenParts.com listened! We are pleased to offer our super sleek billet lightweight crank, water pump,...

GruvenParts.com is proud to release these billet intake drive unit links for ALL VW/Audi VR6 engines with the variable intake manifolds! This part replaces the plastic drive unit linkage which extends from the actuator up to the intake rod shown with...

GruvenParts.com has released this billet VR6 intake manifold drive ball for ALL VW/Audi VR6 engines with variable intake manifolds! This part replaces the white plastic part that attaches to the actuator arm shown with the red arrow in the attached...

MKIV R32, EOS, Touareg, A3, and Audi TT Bushings Now Available! Finally - Replacements for the problematic OEM VW intake manifold shift rod bushings – in most cases theres no need to buy a replacement shift rod!These bushings are sold in...

THESE ARE NOW IN STOCK @ BLOWOUT PRICING !!   Please Note : These are not cheap, made in China castings that will break faster than the OEM plastic part.  These are 100% PRESSURE TESTED TO 100 PSI, MADE IN CALIFORNIA by an Aerospace Tube...

GruvenParts.com is proud to announce the long awaited release of our new BILLET VW/Audi 1.8T / 1.9TDI / 2.0 Upper Radiator Hose 4Y Pipe to replace the OEM Audi/VW plastic 4Y P/N 1J0-121-087C (1J0121087C) This part is found in OEM upper...

*** When Installing These - Please tighten the upper M10 Jam Nut to the Rod End itself.  Tighten the Lower 5/8 Jam Nut to the Center Body.  Please call or email if this is unclear !!  Got a lowered TT MK1 or R32 MKIV ? Then you need to be...

This part replaces the useless rubber donut OEM P/N 035-959-209E (035959209E) that does a poor job supporting your PRICEY auxiliary water pump, and related PRICEY hoses. The OEM rubber donut allows the weight of the pump and hoses to sag, causing stress...